Search results

For those of you who remember BJ and Glen Herzberger, I just spoke to BJ. Today is her 96th birthday. She sounds fine and says she is feeling well. If anyone wants to call her the phone number is 217-323-5014. She says she doesn’t hear from her old GMC friends much anymore. Emery Stora 77...

Larry Her email says June 2004 not 2003. Emery Stora > >>> I am attempting to complete the set. If anyone has any of the following >>> issues and are willing to part with them, please contact me. Thank you. >>> >>> 2002 - November, December >>> 2003 - January, February, April-September >>>...

It’s probably a dry shaft bearing. You might take it apart and grease the shaft or, perhaps get a new blower motor. Emery Stora > > I have an electrical problem and I'm sure it will bite my tush fairly soon. > > > > I have always had a slight high pitch tone with my HVAC fan. It runs on...

Matt I am familiar with restrictions on bridges and tunnels but it appeared that James was referring to roads. Emery > > e in

Which places don’t allow propane use in motion? I guess I must have violated this many time over the years. Emery Stora > > You are correct. It's primary mode of operation is propane. Many places do > not allow propane appliances to operate in motion. That is why the 12 volt > system is...

Reminds me of when I lived in Santa Fe. I had about 300 Piñon trees and 300 Juniper trees on my lot. The beetles killed about 200 Piñon in a year. There were so many dead trees in the area that they were charging $15 each to cut and dispose of the trees. Here in Colorado the Rocky Mountain...

Try a Chevy dealer. The hinge was the same as hinges used on older Surburbans which had two hinged doors on the rear. Probably late 70’s or early 80’s. You might find some in junkyards. Emery Stora 77 Kingsley Frederick CO > >> Thanks to carelessness shutting the door backing up into the...

Tom You don’t have a surge protector. High resistance at a connector will cayse that. Why don’t you try some of the suggestions give you and quit trying to guess. Emery Stora > > Tom, > > I think you're going to find one of the battery cable terminals just about > to come off. The heat...

But the gauge cannot be read to two decimal places. :) Emery > > Ken H you have a miracle vacuum machine there. Since you cannot exceed 29.92 in/hg as that is a perfect vacuum. > -- > John Lebetski > Woodstock, IL > 77 Eleganza II > > > _______________________________________________ >...

John That is not necessarily true. My 1977 GMC has a much larger cable to the up front boost solenoid and is more than adequate to start my engine. What year do you have? Perhaps a prior owner modified yours. In addition to the large factory installed wire from the rear boost solenoid to the...

You really only need one engine battery up front. If it goes dead and won’t start your GMC that is what the boost switch is for — to allow you to start the engine from the rear house batteries. Some people put a second 12 volt house battery up front and run it in parallel to the rear house...

I ordered one from Jim Kanomata about 3 months ago. I didn’t bother with the part number because I knew he would have the right one in stock. Emery Stora 77 Kingsley Frederick CO > > Does anyone have a good part number for the steering damper? > > Moog SSD55 is out of stock everywhere >...

I get hard copies. Check with Kim. Your dues may not be up to date. Emery Stora > > My interchange just has old GM numbers or Use Oil Filter Gasket but it’s 2017. Haven’t gotten hard copies since. > -- > John Lebetski > Woodstock, IL > 77 Eleganza II > > >...

Not only are you pulling in the side but you are also lifting the roof and whatever is on it, such as an air conditioner. I have done a few of these and just pumped the come-a-long until it was in as far as I wanted. I don’t think you can break anything. Emery Stora 77 Kingsley Frederick CO...

Russell While you have it out you definitely should put in a valve before the macerator to make it easier to get it out without making a mess. This is especially important if you have to do it at a campground. I wrote an article for the GMCMI magazine, Page 21 of the > > Our old 1997 Macerator...

Russell While you have it out you definitely should put in a valve before the macerator to make it easier to get it out without making a mess. This is especially important if you have to do it at a campground. I wrote an article for the GMCMI magazine, Page 21 of the Summer 2018 issue of GMC...

Maybe worth it. Does it have the EBL add on? Is it set up for the computer controlled distributor? Emery Stora > > Cool I'm looking at buying a used system but it's for the 403 and I have a 455. Maybe it's worth it? > ________________________________ > From: Gmclist on behalf of Johnny...

On Mon, Jun 15, 2020, 7:35 PM 6cuda6--- via Gmclist >> >> So seeing as how about 90% of the parks on our area are all booked up for >> serviced sites the wife asked about going solar to keep the fridge running >> [12v for the control board with propane] and maybe the odd led light. >> Might...

Some people have attempted to use a hex wrench to take out the plugs and stripped them. When this happened to me I used a very small pipe wrench on the two or three threads of the plug that were exposed and I was able to turn out the plug. Emery Stora > > Drain plugs get hard to pull out if...

If you really want to go from the farthest first you should go right rear, right center, left rear, left center, right front, left front. The two right rear brakes are fed from the same line going across the frame. Emery Stora 77 Kingsley Frederick CO > > When i run into possible brake...