transmission dipstick

ktcnyc

ktcnyc

Member
Sep 14, 2020
99
13
8
Dingmans Ferry, Pa. and NYC
Hello- My coach has a crazy long dipstick for the tranny running to the front of the engine bay -also a cute lil funnel for adding fluid-that's the
good part.
The problem is I can not get a good read on the fluid level. The fluid seems fresh and clear so I can barely tell if the level is OK. I do not want to
overfill but unfilled is well, you know.
Was this converted from a short stick in the engine bay? It's a 1977 with a 455.
Any suggestions on how to read the light colored fluid on the very long stick?
Can or should I convert to a short stick-is that possible?
Thank you for any help on this

Kevin Cloutier
--
Kevin Cloutier -'77 Eleganza II-455, 6 disk brakes, Edelbrock carb, headers, , resident of NYC and Dingmans Ferry, Pa.
'72 MGB-GT & '73 MGB convertible
Member GMCMI since 8/20
 
Yes that long stick is an aftermarket add-on. Yes it could be converted back if desired.

One of the things I do reading oil or trans fluid that is almost transparent, is to take a paper towel and lay the stick after dipping in the
measurement area on the towel. Now you cab see which area of the stick has fluid on it and which area is clean.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
 
You might try roughing up one side of the dipstick area that you read. This might show up the oil better. Also perhaps deepen the grooves that show low and full so that the oil will show in the grooves.

Emery Stora
77 Kingsley
Frederick CO

>
> Yes that long stick is an aftermarket add-on. Yes it could be converted back if desired.
>
> One of the things I do reading oil or trans fluid that is almost transparent, is to take a paper towel and lay the stick after dipping in the
> measurement area on the towel. Now you cab see which area of the stick has fluid on it and which area is clean.
> --
> Ken Burton - N9KB
> 76 Palm Beach
> Hebron, Indiana
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
 
Also the odds of that thing being properly calibrated are not high. I find opening the hatch to check the fluid is also a good time to check PS fluid
and look for any chaffed belts, hoses, errant fluids or ofd odors.
--
John Lebetski
Woodstock, IL
77 Eleganza II
 
> Hello- My coach has a crazy long dipstick for the tranny running to the front of the engine bay -also a cute lil funnel for adding fluid-that's
> the good part.
> The problem is I can not get a good read on the fluid level. The fluid seems fresh and clear so I can barely tell if the level is OK. I do not
> want to overfill but unfilled is well, you know.
> Was this converted from a short stick in the engine bay? It's a 1977 with a 455.
> Any suggestions on how to read the light colored fluid on the very long stick?
> Can or should I convert to a short stick-is that possible?
> Thank you for any help on this
>
> Kevin Cloutier

Kevin,
If rotate the stick until it reflects light, the fluid will reflect differently than does the plain steel. I don't remember if I sanded mine or just
drilled holes in it because I got tired of having to pull out the short stick and then position my body so I could get light to reflect off it.

Question for you...
How do you live in Dingman's Ferry (PA) and NYC. They are at least 60 miles apart with no good road between? (Asked by a refugee from the
megopolis.)

Matt
--
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
 
Greetings from Southern California !!

Don’t know if it’s a good idea or not - but I was shown a trick of lightly dusting the dipstick with a bit of talcum powder.

I don’t recall if this was before inserting the dip stick or after pulling it out - but either way - it more clearly indicates the oil level.

Steve W

--
Steve W
1973 : 23'
Southern California
 
Rough up the back side of the dipstick. 80 grit sandpaper works. Then read
the back side, and turn the stick over. Won't say much for the accuracy of
the long stick. They are wrong more often than right.
Jim Hupy
Salem, Oregon

On Tue, Feb 16, 2021, 7:12 AM Steve Weinstock via Gmclist <

> Greetings from Southern California !!
>
> Don’t know if it’s a good idea or not - but I was shown a trick of lightly
> dusting the dipstick with a bit of talcum powder.
>
> I don’t recall if this was before inserting the dip stick or after pulling
> it out - but either way - it more clearly indicates the oil level.
>
> Steve W
>
>
>
> --
> Steve W
> 1973 : 23'
> Southern California
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
 
> Also the odds of that thing being properly calibrated are not high. I find opening the hatch to check the fluid is also a good time to check PS
> fluid and look for any chaffed belts, hoses, errant fluids or odd odors.

"That thing"...? You're such a purist, John! :p

I bought my remote dipstick from a vendor and was told that the stick is correctly calibrated for the GMC. You've heard the expression about getting
the short end of the stick, and that's bad, right? The expression came from the short GMC dipstick...I will be creating the Wikipedia reference page
shortly to back me up on this.

I wouldn't go back to the let's-blast-hot-air-and-dust-into-the-coach-while-making-it-onerous-to-perform-frequent-maintenance short stick.

All the other under hatch inspection can be done with the engine off. That's how I prefer to do it.

Richard
--
'77 Birchaven TZE...777;
'76 Palm Beach with 18,477 verified miles;
‘76 Edgemonte
 
>
> I wouldn't go back to the let's-blast-hot-air-and-dust-into-the-coach-while-making-it-onerous-to-perform-frequent-maintenance short stick.
>
> All the other under hatch inspection can be done with the engine off. That's how I prefer to do it.
>
> Richard

Richard,

If your fan clutch works right, the cold fan will be disengaged before you can get the engine hatch loose.

Matt
--
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
 
You must log in or register to reply here.
Get your shine on at www.cruzingear.co
Applied GMC

Share this page

Share this page
Top Bottom
Back