Thrust bearings

[steven d. ferguson]

Than maybe you can tell everyone how to properly center the thrust
bearings
Steve. Lack of it is one of the biggest reasons for crank failure in
rebuilt engines

Perhaps you'd better Tom, it's your thread and obviously you're quite
sure of your methods. I'll let you know if you're correct.
Steve Ferguson
San Diego

 

[steven d. ferguson]

Sorry Tom,
No hostility on my part. You just ticked me off momentarily by what I viewed
as your trying to set me up for failure when I mistakenly thought I was actually
helping people do the right thing.
I apologize for letting myself lose control and lowering myself to your
level. It must be difficult at times for you to be the only adult in a roomful
of misguided children.
Nuff said! I'll respond to no further posts from you so this doesn't happen
again. By the way, nice puller.
Steve Ferguson

> Steve do I see a little bit of hostility here? Whats the problem and since
> when has it been my thread? I do in fact know how to do it, but why dominate
> the thread if their are other knowledgable individuals like you.
>
> Note that you were not to hostile to buy one of my bearing pullers though!
>

> >
> >Than maybe you can tell everyone how to properly center the thrust
> >bearings
> >Steve. Lack of it is one of the biggest reasons for crank failure in
> >rebuilt engines
> >
> >Perhaps you'd better Tom, it's your thread and obviously you're quite
> >sure of your methods. I'll let you know if you're correct.
> >Steve Ferguson
> >San Diego
> >
> >