Must be rust and crud where
it enters the block because the gear at the bottom shouldn't be holding
it.
I've found quite a few like that. Usually is varnish build up where the
distributer goes through the block. (In 2 places.) You can use a pipe
wrench on the raised part of the base, It's gonna leave a lasting
impression in the housing though. Sometimes it's the only way. WD
ain't gonna get it!
Steve
it enters the block because the gear at the bottom shouldn't be holding
it.
I've found quite a few like that. Usually is varnish build up where the
distributer goes through the block. (In 2 places.) You can use a pipe
wrench on the raised part of the base, It's gonna leave a lasting
impression in the housing though. Sometimes it's the only way. WD
ain't gonna get it!
Steve
