Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts.

B

Bob Dunahugh

New member
Sep 17, 2012
2,784
4
3
Yes. The wiring, and fuel line. But it's just those 4-1/4 inch bolts on each side of the slid track. Something is just wrong. It can't be that simple.

Bob Dunahugh
 
Yep. Just put some tension on the eyebolt with the engine hoist and start removing them. Bob are you at MCACN show this year?
--
John Lebetski
Woodstock, IL
77 Eleganza II
Source America First
 
Yep. Just put some tension on the eyebolt with the engine hoist and start removing them. Bob are you at MCACN show this year?
--
John Lebetski
Woodstock, IL
77 Eleganza II
Source America First
 
I always loved the 'works in the drawer' Onans.
Most SOBs did not have them. A few had swing down mounts which made service and removal easier, but you couldn't run them tilted
ours are much easier to work on.

Speaking of which, helped a friend tear down an oman Marquis 7.0 that was locked up. FAR more involved. Plenty of FU bolts.
turned out to be the pulley end motor bearing fragged.
--
76 Glenbrook
 
You must log in or register to reply here.
Applied GMC
GMCMI Fall 2026 Rally

Share this page

Share this page
Top Bottom
Back