OTC Puller

[d. winchtester]

I just got home and found my OTC Push-Puller on my door step, unfortunately
to late to call JSC about the tool so I thought I would ask the list a
question.

How many pieces should I find in the box? What I found was three pieces,
the cross block, one threaded shaft, and two shafts threaded on both ends.
There was a single sheet of instructions that mentions Forcing Nut, other
washers, Nut & sliding plate but none of this are present. Am I missing
part of the Tool?

 

[john wright]

Your missing the bag of parts.
J.R.

>
> I just got home and found my OTC Push-Puller on my door step, unfortunately
> to late to call JSC about the tool so I thought I would ask the list a
> question.
>
> How many pieces should I find in the box? What I found was three pieces,
> the cross block, one threaded shaft, and two shafts threaded on both ends.
> There was a single sheet of instructions that mentions Forcing Nut, other
> washers, Nut & sliding plate but none of this are present. Am I missing
> part of the Tool?

 

[nate chase]

Dan,
Just got mine yesterday. Had another bag of the nuts, washers and sliding
plates in it (2 each except 3 nuts). Call them up and ask "Where your bag of
nuts went?".

Nate '75GB (storing my nuts for winter) Omaha

PS. Say, did you get Tom's puller yet???


Date: Tue, 21 Sep 1999 16:23:00 -0700
From: "Dan Winchester"
Subject: GMC: OTC Puller

I just got home and found my OTC Push-Puller on my door step, unfortunately
to late to call JSC about the tool so I thought I would ask the list a
question.

How many pieces should I find in the box? What I found was three pieces,
the cross block, one threaded shaft, and two shafts threaded on both ends.
There was a single sheet of instructions that mentions Forcing Nut, other
washers, Nut & sliding plate but none of this are present. Am I missing
part of the Tool?