Due to the crossover design of the intake manifold each injector feeds 2 cylinders on the left side and 2 cylinders on the right side. So the mixture reading by a sensor on the left side would be the same as the reading by a sensor on the right side. So, only one sensor would be needed as readings on both sides would be the same.
Emery Stora
77 Kingsley
Frederick CO
Emery
>
> Then, the possibility exists that "bad stuff" might happen.
> The ideal setup would be egt sensors in each and every exhaust port
> connected to a computer that will record actual exhaust gas temperatures,
> and do something like shut the engine down if a dangerous condition occurs.
> It would have to be quicker than human reaction times to be effective.
> By the time humans notice something wrong and take action, damage is
> already occurring. When "sh## happens" it is on the timeline of
> nanoseconds and seconds, not minutes.
> Jim Hupy
> Salem, Oregon
>
>>
>> So Bob,
>> the O2 reads one side, assuming the injectors on the other side is
>> functioning correctly..
>> What if it is not??
>>
>>>
>>> Remember. The left side of the carb or TB. Feed cylinder's 2, and 8 on
>> the
>>> right-side, and cylinders 1, and 7 on the left. The right side of the
>> carb
>>> or TB. Feed cylinders 4, and 6 on the right side, and 3,and 5 on the left
>>> side. Thus. Only one O2 sensor is required.
>>> Sorry. See what happens if I get started on engines, or Royales. GRIN.
>>> Bob Dunahugh
>>> 78 Royale since 2003
>>> 4 Real COPO Yenkos
>>>
>>> GMC Motorhome Forum
https://www.gmcmotorhome.org/
>>>
>>> Visit GMC Motorhome Forum
https://www.gmcmotorhome.org/
>>> _______________________________________________
>>> GMCnet mailing list
>>> Unsubscribe or Change List Options:
>>>
>>
>>
>> --
>> Jim Kanomata
>> Applied/GMC, Newark,CA
>> jimk
>>
http://www.gmcrvparts.com
>> 1-800-752-7502
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options: