We replaced the oil send unit on the Onan and now it won't crank.
Jumpered pins 11 and 9 on the circuit board (fuel pump & ignition)
and it started right up (with the switch). Removed the jumper wire
and it ran fine until it was stopped with the switch. Put the old oil
send unit back in but it still wouldn't crank. Please respond to us
privately at livingpraise because we are on the
road and can't download all of the messages from the list. Any
suggestions will be GREATLY appreciated.
Thanks a lot,
Les and Des
73 Painted Desert
Rocky Mount, NC
mailto:lpraisee
vist us at: http://www.livingpraise.org
Jumpered pins 11 and 9 on the circuit board (fuel pump & ignition)
and it started right up (with the switch). Removed the jumper wire
and it ran fine until it was stopped with the switch. Put the old oil
send unit back in but it still wouldn't crank. Please respond to us
privately at livingpraise because we are on the
road and can't download all of the messages from the list. Any
suggestions will be GREATLY appreciated.
Thanks a lot,
Les and Des
73 Painted Desert
Rocky Mount, NC
mailto:lpraisee
vist us at: http://www.livingpraise.org
