Onan 6 NH Choke problem

[Matt Colie]

Because I am kind of a sucker.... I have the 6.0 Onan (NH) in my barn. I have a friend that wanted it out, and another friend that wanted it. It
hasn't been started in more than four years. "But it ran then"!

I was getting set to run test it and I noticed that the lever on the choke operator was not moving. Well, it isn't sticky. It is seized. I didn't
try any more. Does any one have a success story that starts about here?
That or a replacement part that could be available?

If I hear none, I will attempt to deal with this and report regardless of the outcome.

Matt
--
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit

 

[LQQKatJon]

Matt,

reach out to Jim Miller. I think he came up with a solution for the way too expensive and rare onan choke. I think he mentioned that last time I
talked to him.

--
Jon Roche
75 palm beach
EBL EFI, manny headers, Micro Level, rebuilt most of coach now.
St. Cloud, MN
http://lqqkatjon.blogspot.com/

 

[john r. lebetski]

GM 1052627 heat valve penetrant and lube.
Obsolete but on eBay.
--
John Lebetski
Woodstock, IL
77 Eleganza II

 

[Ken B]

If you are going to remove it, then put it is a can and soak the whole thing in ATF or PSF and Acetone 50/50 for a couple of days.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana