MT Valve Covers

[nate chase]

[Admin note - "Bounced", non-member submission. Nate, you need to post
from the account you're subscribe at to prevent "bounces". Patrick]

Patrick,
On my Caspro engine w/MT's they seem to just barely make it. Jim would
know if they had any problems installing the AC Compressor, etc..

Nate 75GB (80 degrees yesterday while on the "Bad Boy") Omaha

>
Date: Thu, 21 Oct 1999 07:11:39 -0500
From:
Subject: GMC: MT Valve Covers(was GMC Motorhome Digest V3 #115)

Arch,

I hope I'm not opening a can of worms here, but with the accessory
brackets
clear the MT valve covers?

Patrick

> Did not like leaking sheet metal valve covers. Finally found Mickey
> Thompson cast ones.

 

[nate chase]

Arch,
Better thank Patrick on this one... he was nice enough to push through my
bounced message or you'd have never have gotten it! Glad I could help...
I needed a break anyways. Been slow smokin' 30 lbs of Baby Backs this
afternoon... yummy!

Nate '75GB (Squirreling away for winter, I guess) Omaha


Re: GMC: MT Valve Covers

In a message dated 10/23/99 7:13:40 AM Central Daylight Time,

> On my Caspro engine w/MT's they seem to just barely make it. Jim would
> know if they had any problems installing the AC Compressor, etc..

Nate

THANKS!! I had measured everything many times and thought it would
work. Glad to hear someone else picked the same ones I did. They
were the only ones I could find that were not square on the ends.
Nate you made my day----thanks again.

Take Care
Arch