Kendra is looking for drawings for GMC cabinets

[Matt Colie]

Copied from GMC Motorhomes forum.

Yesterday at 11:18 PM

Short term I'm fine with the original particle board cabinets. A bit rough but they get the job done.

Longer term I'd like to replace all the particle board with higher quality wood cabinets and fittings - in most cases following original measurements
and layout. I don't have the skills to build these, so I'll need to take a set of drawings to a cabinet shop or boat interior specialist.

Has anyone found or created a detailed set of cabinet drawings based on the original GM 26' set?
I searched here, GMCMH Photos, GMCMI folders, etc.

thanks!
-Kendra
Kendra Fowles, Seattle, 1978 Kingsley

I these are in the files somewhere, I will forward the location to Kendra.

Matt
--
Matt & Mary Colie - Chaumi��re -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit

 

[Ken B]

There is a guy in Calgary, I forget his name at the moment, that use to make replacement cabinets out of aluminum. As soon a I remember his name I
will post it. He should have the measurements you want.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana

 

[Larry Davick]

Was it Darren Paget? I remember he did this as a hobby - his focation was firefighter, if memory serves me.

Larry Davick

>
> There is a guy in Calgary, I forget his name at the moment, that use to make replacement cabinets out of aluminum. As soon a I remember his name I
> will post it. He should have the measurements you want.
> --
> Ken Burton - N9KB
> 76 Palm Beach
> Hebron, Indiana
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options: