House hot water heater issues

LarryW

Well-known member
Mar 28, 2002
6,019
744
113
Menomonie, WI.
I've got a 6 gal Atwood LP hot water heater. I turn it on and it lights and runs for about 5 seconds. Shuts off for 3-4 seconds and restarts. Does
this maybe 5 times and stops. Gotta turn it off and it will do it all over again. Sometimes during this cycle it will lite and stay lit for the
duration. Sometimes it will light during one of the cycles and after 5 minutes of burning it will shut off and not relight. I have cleaned off the
igniter, and that did not work. What does the collective intelligence think I should do next?

--
Larry
78 Royale w/500 Caddy
Menomonie, WI.
 
It sounds to me that the module is going bad.

Emery Stora
77 Kingsley
Frederick, CO

>
> I've got a 6 gal Atwood LP hot water heater. I turn it on and it lights and runs for about 5 seconds. Shuts off for 3-4 seconds and restarts. Does
> this maybe 5 times and stops. Gotta turn it off and it will do it all over again. Sometimes during this cycle it will lite and stay lit for the
> duration. Sometimes it will light during one of the cycles and after 5 minutes of burning it will shut off and not relight. I have cleaned off the
> igniter, and that did not work. What does the collective intelligence think I should do next?
>
>
> --
> Larry
> 78 Royale w/500 Caddy
> Menomonie, WI.
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
 
I am not familiar with that heater but is there a thermocouple / sensor that tells the control module when the flame is burning? Most gas fired
devices have one. If no flame is sensed then the gas is turned off and it retries several times before shitting off completely.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
 
What Ken said - second most is the overtemp sensor. It should be on the outlet stack someplace and may be opening at too low a temp, ot the
stack/vent may be blocked somewhat. Check both.

--johnny
--
76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
"I forgive them all, save those who hurt the dogs. They must answer to me in hell" - ol Andy, paraphrased
 
I've got a 6 gal Atwood LP hot water heater. I turn it on and it lights and
runs for about 5 seconds. Shuts off for 3-4 seconds and restarts. Does
this maybe 5 times and stops. Gotta turn it off and it will do it all over
again. Sometimes during this cycle it will lite and stay lit for the
duration. Sometimes it will light during one of the cycles and after 5
minutes of burning it will shut off and not relight. I have cleaned off the
igniter, and that did not work. What does the collective intelligence think
I should do next?

--
Larry
78 Royale w/500 Caddy
Menomonie, WI.