holding tank connections

[james melberg]

We have a '75 Palm Beach. Bought it last summer.
Looked great. We had to replace the frame from the
front frame assembly back (rails, bogie brace, rear
frame assemby) as they were very badly rusted. As
near as we can tell, the rust may have been caused by
leakage from cracked tank connections from the kitchen
sink and from the bathroom unit. These are plastic
fittings that screw into the tank and have o-rings in
them to provide a seal when they are slipped up over
plastic pipe stubs coming down thru the unit floor.
One fitting is 1 1/2" and the other is 2". We have
not yet reinstalled the holding tank because of the
cracked fittings. Can't seem to find replacements.
Can anyone help? We have tried Cinnabar with no luck.

Jim

=====

__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com

 

[james melberg]

Sorry it took so long to come up with numbers. My 78Z
was on board the coach in my sons driveway up north.

The figure is 23.110 on pg 23-82
One of the items is shown in the blowup of item 6
It is the screw-in fitting with o-ring, p/n 790052.
This fitting is for 2 inch diameter pipe. The other
fitting is shown but not called out. It will be
similar to 790052 except for 1 1/2 inch pipe.

Thats the best I can do.

I do have catalogue information coming snail mail from
Thetford. The more info the better.

Jim

=====

__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com