Thanks Jim. I do have a new valve I bought from you. I tested it and it works fine. The hot wire to the valve is not getting power. I was hoping it was a bad fuse I missed, but it looks like I’m going to have to trace the wire. The gas gauge are working for both tanks. Am I missing something?
Thanks again!
Sent from my iPhone
>
> You do need to replace it if original as the rubber inside will give
> problems.
> Go to our web site under Fuel.
>
>>
>> You can find the wiring diagrams here:
>>
>>
http://www.bdub.net/wirediagrams
>>
>> Looks like you have a 1973, so they are at the top of the list. Get both
>> the engine (Chassis) and the house wiring diagrams while you are at it.
>>
>> The selector switch is a double pole switch. One side selects which tank
>> sender gets connected to the gas gauge and the other side sends 12V to the
>> selector valve when in the Aux position.
>>
>> --
>> Bruce Hislop
>> ON Canada
>> 77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.1 ton front end
>>
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
>> My Staff says I never listen to them, or something like that
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>>
>
>
> --
> Jim Kanomata ASE
> Applied/GMC, Newark,CA
> jimk
>
http://www.gmcrvparts.com
> 1-800-752-7502
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options: