[Admin note - Alan, This bounced as a non-member submission. Be
sure your "From" header matches the address you're subscribed at.
Patrick]
When I bought my 1974 coach the air system had been buggered almost
beyond recognition. The air bags simply had schrader valves installed
on them. Air lines were hanging out of the dash. I used 5 manual 3 way
valves and jury rigged a usable system (that hangs out of the dash). I
would be interested if someone found a reasonable cost alternative. Of
course I don't have time to do it right now as I am in the middle of a
poop tank and pottie replacement as well as rear bearings on all four.
Going for two weeks to upstate New York then Nashville then South
Carolina to drop kid off at college. Leaving 8/14/99, think I'll get it
done in time?
>From: Patrick Flowers [mailto
atrick]
>Sent: Saturday, July 31, 1999 3:37 PM
>Subject: GMC: ElectroLevel Valves
>I've been toying with the idea of converting my coach
>from the PowerLevel system to a system similar to
>ElectroLevel I. I've found a source for miniature
>12V air valves. 3 valves mounted on a compact manifold
>would run around $145 - less with a large quantity
>order. Two sets would be required for the conversion.
>If there's any interest, let me know and I'll pursue it
>further.
sure your "From" header matches the address you're subscribed at.
Patrick]
When I bought my 1974 coach the air system had been buggered almost
beyond recognition. The air bags simply had schrader valves installed
on them. Air lines were hanging out of the dash. I used 5 manual 3 way
valves and jury rigged a usable system (that hangs out of the dash). I
would be interested if someone found a reasonable cost alternative. Of
course I don't have time to do it right now as I am in the middle of a
poop tank and pottie replacement as well as rear bearings on all four.
Going for two weeks to upstate New York then Nashville then South
Carolina to drop kid off at college. Leaving 8/14/99, think I'll get it
done in time?
>From: Patrick Flowers [mailto
atrick]>Sent: Saturday, July 31, 1999 3:37 PM
>Subject: GMC: ElectroLevel Valves
>I've been toying with the idea of converting my coach
>from the PowerLevel system to a system similar to
>ElectroLevel I. I've found a source for miniature
>12V air valves. 3 valves mounted on a compact manifold
>would run around $145 - less with a large quantity
>order. Two sets would be required for the conversion.
>If there's any interest, let me know and I'll pursue it
>further.
