Brake Booster to MC rod clearance.

[Ken B]

Well I have searched all over for a couple of hours and find all kinds of numbers from .005" to .020". How about some opinions on what it should be.

Ken B.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana

 

[RF_Burns]

I just got a new booster and master cylinder from Dave Lenzi. He provides a new pin with it matched to 0.020" clearance.

--
Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that

 

[Ken B]

Thanks Bruce. I ground a new pin yesterday and it is set about .015.

Too hot here to take it out so I'm not sure yet if it works or not.

Sidetracked on other things. My home AC quit and so did my water softner. So I'm off working on them. Temp suppose to be in middle 90's but I still
have to go outside and work on the AC.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana