Tom is correct. In the late summer I bought two Timken A-23 sets for
$50.70 Cdn each. It was from a bearing and seal specialty distributor called
Canadian Bearing. I asked for nothing except .0095" clearance bearings and
they had to come from Timken in the US. Canada or at least Ontario was out
of stock. The invoice that came with them had something on it like "A-23
set - .0095 in - special application". The four seals were expensive. I'm
not sure but I know the four were over $50.00 Cdn. So the cost per side was
about $75.00 /$50.00 US.
Manny, I just looked at the driver's door & slideout pictures -
beautiful job!
Al Hamilton
76 Elegenza II
Kingston, Ont
$50.70 Cdn each. It was from a bearing and seal specialty distributor called
Canadian Bearing. I asked for nothing except .0095" clearance bearings and
they had to come from Timken in the US. Canada or at least Ontario was out
of stock. The invoice that came with them had something on it like "A-23
set - .0095 in - special application". The four seals were expensive. I'm
not sure but I know the four were over $50.00 Cdn. So the cost per side was
about $75.00 /$50.00 US.
Manny, I just looked at the driver's door & slideout pictures -
beautiful job!
Al Hamilton
76 Elegenza II
Kingston, Ont
