Wayne,
I will get with Scott so he can post the control arm template. I
drilled a 1 1/8 hole in a piece of 1/8 steel. The hole is centered over
the balljoint stud and is large enough for a socket to fit inside. I
then traced around the tip of the control arm and cut it out. The piece
is about 2 1/2 X 4.
The other Jim
I will get with Scott so he can post the control arm template. I
drilled a 1 1/8 hole in a piece of 1/8 steel. The hole is centered over
the balljoint stud and is large enough for a socket to fit inside. I
then traced around the tip of the control arm and cut it out. The piece
is about 2 1/2 X 4.
The other Jim
