Arch,
I don't know if this helps in your decision, but I just installed a
Norcold 461, had to shave 1/2" off the top of the opening & install 1/2"
trim on the sides in order to get it to "flush" up with the opening. I
mounted the fan off my original ceiling vent in the rear opening, tipped
slightly upwards, so it blows directly on the cooling coils. With the
temp setting on "7", the case of beer I stocked the refer with was
slightly slushy by the next day, had to turn down the temp.
I haven't hooked up the propane yet as I'm not sure where to tap into
for a source. Ideas?
Steve Ferguson
'76 EII San Diego
I don't know if this helps in your decision, but I just installed a
Norcold 461, had to shave 1/2" off the top of the opening & install 1/2"
trim on the sides in order to get it to "flush" up with the opening. I
mounted the fan off my original ceiling vent in the rear opening, tipped
slightly upwards, so it blows directly on the cooling coils. With the
temp setting on "7", the case of beer I stocked the refer with was
slightly slushy by the next day, had to turn down the temp.
I haven't hooked up the propane yet as I'm not sure where to tap into
for a source. Ideas?
Steve Ferguson
'76 EII San Diego
